Módulo de memoria ADATA LANCER DDR5 32 GB 6000 MHz

A New Speed ​​Benchmark in Gaming Memory
The XPG LANCER ushers in the DDR5 era for gaming memory. Reaching frequencies of up to 7200 MT/s, It will give you a major performance boost for gaming and overclocking.

Enhanced Power Management
The XPG LANCER DDR5 features a built-in Power Management IC (PMIC) that enhance power supply stability. It's lower operating voltage also make LANCER more power-efficient than DDR4.

Stability and Reliability
With On-die error correcting code (ECC) this module can correct errors in real-time to provide increased stability and reliability.

Made with High-Quality Materials
High-quality ICs and PCBs ensure uncompromised performance and reliable overclocking, ideal for discerning gamers and overclockers.

AMD EXPO
Support for AMD EXPO (EXtended Profiles for Overclocking) and compatibility with the latest platforms for reliability and stability.

Overclocking Made Easy
With support for Intel XMP 3.0, get overclocking easily without the need to hassle with BIOS settings. There is no need to repeatedly adjust and fine-tune overclocking parameters.

QuikTips: DDR5 vs DDR4 - Appearance
DDR5 U-DIMM modules have the same dimensions and pin count as DDR4 modules. The most obvious difference is the position of the fool-proof notch. Also, DDR5 integrates I/O resistors with CMD/ADD resistors. Also, the appearance of DDR5 modules are cleaner than DDR4. In addition, you can see a PMIC in the center.

QuikTips: DDR5 vs DDR4 - Performance
The biggest change is that bandwidth and frequency are significantly higher. The ADATA DDR5 memory modules deliver frequencies of up to 4800MT/s and feature bandwidth of 38.4GB/s, which is 50% higher than the DDR4-3200. The maximum frequency is increased 1.63 times compared to DDR4.

QuikTips: DDR5 vs DDR4 - Chip Architecture
DDR5 modules provide two times more capacity than DDR4 by packing in more banks and bank groups. In addition, Burst Length and Prefetch are also doubled. And to ensure data integrity, they feature error correcting code (ECC) technology.

XPG LANCER. Component for: PC, Internal memory: 32 GB, Memory layout (modules x size): 2 x 16 GB, Internal memory type: DDR5, Memory clock speed: 6000 MHz, Memory form factor: 288-pin DIMM, CAS latency: 30

How to use

Power off the PC and disconnect it from the mains. Open the computer case according to the manufacturer’s instructions, locate the compatible DDR5 DIMM slots on the motherboard and release the slot latches. Align each module with the slot notch and insert the modules evenly until the latches click into place. Close the case, reconnect power and start the system; the motherboard should detect the dual-channel 32 GB kit automatically. Check BIOS/UEFI settings if specific XMP or profile activation is required for rated 6000 MHz operation.

Recommendations

Install the modules in matching DIMM slots to enable dual-channel mode and, if needed, enable the appropriate memory profile (XMP/EXPO) in BIOS/UEFI to reach the rated 6000 MHz. Ensure your motherboard and CPU support DDR5 6000 MHz before use.