Módulo SFP+ InLine de fibra óptica 850nm multimodo con conectores hembra LC, 300m, 10Gb/s

The InLine SFP+ module is a Small Form-Factor Pluggable transceiver designed for 10 Gigabit Ethernet links over multimode fiber. It supports a data rate of 10 Gb/s at an 850 nm wavelength and uses LC duplex connectors. The module is intended for short-reach network connections up to 300 metres and is powered by a 3.3 V supply.

Advantages

The SFP+ module provides a compact, hot-pluggable solution for adding 10 Gb/s fiber connectivity to compatible switches, routers or media converters. Its multimode 850 nm design and LC sockets ensure compatibility with common multimode fiber cabling, while the specified 300 m reach covers typical campus and data centre short-reach links. The single-unit format simplifies installation and replacement.

Suitable for

• Short-reach 10 Gb/s uplinks within data centres
• Campus and building backbone links over multimode fiber
• Upgrading switches or media converters to support 10 Gigabit connections

Key specifications

• Maximum data transfer rate: 10000 Mbit/s (10 Gb/s)
• Maximum transfer distance: 300 m over multimode fiber
• Wavelength: 850 nm
• Connector type: LC duplex
• Form factor: SFP+
• Power supply: 3.3 V
• Brand: InLine, MPN: 32335P, EAN: 4043718334896

How to use

Install the SFP+ module into a compatible SFP+ port on a switch, router or media converter while the device is powered according to the host equipment manual. Connect LC-terminated multimode fiber patch cords to the module's LC sockets, observing correct transmit/receive pairing. Configure the host device for 10 Gb/s operation if necessary and verify link status through the device management interface. For hot-pluggable operation, follow the host manufacturer's guidance to avoid link interruptions.

Recommendations

Use OM3/OM4 multimode fiber for reliable performance at the full 300 m distance, keep fiber connectors clean, and verify host compatibility with SFP+ modules that operate at 850 nm before deployment.