Módulo transceptor de fibra óptica BlueOptics 551105-BO 1250 Mbit/s SFP

The BlueOptics 551105-BO 1250 Mbit/s SFP is a compact fiber optic transceiver module designed for single-module insertion in compatible network equipment. With a maximum data transfer rate of 1250 Mbit/s and a standard SFP form factor, this silver-coloured module provides a direct optical interface for short- to medium-range fiber connections. The module is lightweight at approximately 20 g and is manufactured to meet CE, FCC and RoHS conformity, offering a measured mean time between failures (MTBF) of 1,000,000 hours.

Advantages

The BlueOptics 551105-BO offers standardized SFP compatibility that facilitates hot-swappable installation in switches, routers and media converters. Its 1250 Mbit/s throughput supports Gigabit Ethernet and related optical links where this data rate is required. The compact SFP form factor and low weight simplify deployment in high-density patch panels and chassis, while CE, FCC and RoHS compliance indicates adherence to common regulatory and environmental requirements. A high MTBF figure contributes to predictable operational availability in network environments.

Suitable for

• Upgrading or replacing SFP ports in switches and routers that accept standard SFP transceivers
• Establishing fiber links for Gigabit Ethernet and similar 1250 Mbit/s optical connections
• Use in server rooms, campus networks and service-provider aggregation points requiring standardized SFP modules

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Interface type: fiber optic SFP
• Colour: silver
• Weight: approximately 0.02 kg
• Regulatory compliance: CE, FCC, RoHS
• Reliability: MTBF 1,000,000 hours

How to use

Install the BlueOptics 551105-BO by inserting the SFP module into an empty SFP slot on a compatible switch, router or media converter until it clicks into place. Connect the appropriate fiber optic patch cable to the transceiver module, ensuring correct connector type and polarity. After insertion, verify link status and configuration on the host device; most systems detect standard SFP modules and enable the port automatically or via standard port configuration procedures. To remove, power down the port if required by your equipment and gently pull the module from the host slot using the integrated release mechanism.

Recommendations

Use the BlueOptics 551105-BO in systems that explicitly support standard SFP modules and the 1250 Mbit/s optical rate. Match the transceiver to appropriate fiber type and connector (single-mode or multi-mode) and maintain clean connector end-faces to preserve signal quality. Observe electrostatic discharge precautions during handling and store spare modules in protective packaging to avoid contamination and mechanical damage.