Módulo transceptor SFP BlueOptics 3HE00266AA-BO 155 Mbit/s

The BlueOptics 3HE00266AA-BO SFP transceiver module is a compact fiber optic interface engineered for network equipment requiring an SFP form factor and a maximum data transfer rate of 155 Mbit/s. Designed to fit standard SFP ports, the module offers a lightweight silver housing and a high mean time between failures (MTBF) of 1,000,000 hours, supporting stable operation in telecommunications and data communication environments. Compliance with CE, FCC and RoHS ensures it meets common regulatory and safety requirements.

Advantages

The module’s SFP form factor provides compatibility with a wide range of switches and routers that accept small form-factor pluggable transceivers. With a specified maximum throughput of 155 Mbit/s, it is suitable for legacy and specific low-bandwidth fiber links. Its high MTBF indicates long-term reliability and reduced need for frequent replacements. The lightweight silver enclosure simplifies handling and installation without adding significant weight to networking hardware.

Suitable for

• Installation in network switches and routers with SFP ports
• Fiber optic links requiring up to 155 Mbit/s data rate
• Telecommunications equipment and industrial network segments
• Environments where compliant CE, FCC and RoHS components are required

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 155 Mbit/s
• MTBF: 1,000,000 hours
• Product colour: Silver
• Weight: 0.02 kg
• Regulatory compliance: CE, FCC, RoHS

How to use

Ensure the host device supports SFP transceivers and is powered down or follows hot-swap guidelines from the equipment manufacturer. Align the BlueOptics SFP module with the SFP port and insert until it clicks or seats firmly according to the switch or router’s installation procedure. Connect the appropriate fiber optic cable to the transceiver’s connector, taking care to use the correct cable type and polarity for the link. Verify link status and configure the network device as required to enable the interface and set the appropriate speed and duplex settings if applicable.

Recommendations

Use clean, undamaged fiber cables and dust caps when the transceiver is not connected. Follow electrostatic discharge (ESD) precautions during handling, and consult the host device documentation for compatibility and supported feature sets to ensure stable operation at the specified 155 Mbit/s rate.