Módulo transceptor de fibra óptica BlueOptics JNP-SFP-10G-BX40D-BO SFP+ 40000 m

The BlueOptics JNP-SFP-10G-BX40D-BO is an SFP+ fiber optic transceiver module designed for 10G optical links over single-mode fiber with a reach of up to 40,000 meters. Housed in aluminum and weighing approximately 20 g, the module provides a compact form factor with LC simplex connectivity and supports bidirectional transmission with separate transmit (1270 nm) and receive (1330 nm) wavelengths. The transceiver follows MSA standards for SFP+ form factor and is engineered for use in networking equipment that supports compatible 10GBASE-BX-D modules.

Advantages

The module offers long-reach 10G data transmission over single-mode fiber while maintaining a lightweight, robust aluminum enclosure for reliable installation. It supports digital diagnostics (DDM/DOM) for real-time monitoring of supply voltage, laser bias current, transmit power, receive power and temperature, enabling easier maintenance and fault analysis. Components are selected to meet common industry quality standards and the module is tested for compatibility with major platforms that accept equivalent 10GBASE-BX-D SFP+ transceivers.

Suitable for

• Long-distance 10 Gigabit Ethernet links over single-mode fiber
• Interconnecting switches, routers and storage systems across campus or metro networks
• Replacement of compatible 10GBASE-BX-D SFP+ transceivers in supported hardware
• Environments requiring remote optical link monitoring via DDM/DOM

Key specifications

• Interface type: SFP+ (10G)
• Optical mode: Single-mode fiber
• Wavelengths: Transmit 1270 nm / Receive 1330 nm
• Connector: LC Simplex
• Maximum reach: up to 40,000 m (40 km)
• Housing material: aluminium
• Weight: approximately 0.02 kg
• Digital Diagnostics: DDM/DOM compliant (MSA SFF-8472)

How to use

Install the BlueOptics SFP+ transceiver into an SFP+ slot of a compatible switch, router or storage device according to the host equipment manufacturer’s instructions. Connect an LC simplex single-mode patch cable between transceivers or to a patch panel to establish the optical link. Verify that the host device supports 10GBASE-BX-D compatible modules and enable any required interface settings. If DDM/DOM monitoring is available in the hardware, use the host management interface to read diagnostic parameters for link verification and troubleshooting.

Recommendations

For optimal performance, use single-mode fiber and high-quality LC simplex patch cords, ensure proper cleaning of connectors before mating, and confirm firmware or software compatibility on the host device. Use DDM/DOM readings to verify link health and plan maintenance; avoid exceeding specified operational temperature and power ranges as defined by the host equipment.