Transceptor de cobre SFP+ CBO para Palo Alto Networks SFP-10G-RJ45-80M 10 Gbit/s

BlueOptics SFP+ copper transceiver CBO compatible with Palo Alto Networks SFP-10G-RJ45-80M provides 10 Gbps connectivity over standard RJ45 copper cabling. The module is designed for insertion into SFP+ ports on switches, firewalls and servers to enable 10 Gigabit Ethernet links without changing existing copper infrastructure. It supports short-range copper connections according to the supported distance of the original form factor and is suitable where a direct 10G copper uplink is required.

Advantages

This SFP+ copper transceiver offers a compact, hot-pluggable solution for adding 10 Gigabit Ethernet over RJ45 copper to compatible devices. It enables reuse of copper cabling, simplifies hardware upgrades, and reduces the need for fiber in short-distance links. The module is engineered for standard SFP+ ports and offers interoperability with devices that accept the stated Palo Alto Networks compatible module type.

Suitable for

• 10 Gbps uplinks between switches and aggregation points over copper
• Connecting firewalls and servers to switch ports that accept SFP+ copper modules
• Short-range 10 Gigabit Ethernet links in data centers and server rooms using Cat6/Cat6a cabling

Key specifications

• Data rate: 10 Gbps
• Connector: RJ45 (copper)
• Form factor: SFP+
• Cabling: Standard twisted-pair copper (Cat6 / Cat6a recommended for 10G)
• Operating mode: Hot-pluggable insertion into SFP+ ports
• Typical use range: short-reach copper links (depends on cable category and environment)

How to use

Insert the transceiver into a compatible SFP+ slot until it latches, then connect the RJ45 copper cable between network devices. Verify link status via the device management interface or indicator LEDs and confirm negotiated speed of 10 Gbps. If necessary, check device compatibility settings and firmware to ensure the port accepts third-party SFP+ copper modules. Remove the module by depressing the release mechanism and pulling it out while minimizing static exposure.

Recommendations

Use high-quality Cat6a or Cat6 cables for reliable 10 Gbps performance and keep copper cable runs within recommended short-reach distances. Confirm compatibility with the target device and monitor link status after installation. Handle the module carefully and store it in an anti-static environment when not in use.