Módulo transceptor de fibra óptica BlueOptics LE0M0XSM88-BO SFP+ LC aluminio 20g

The BlueOptics LE0M0XSM88-BO SFP+ LC Aluminium 20g is a fiber optic transceiver module designed for 10 Gbps short-range links over multimode fiber. It uses an SFP+ interface and an LC duplex connector in an aluminium housing weighing approximately 20 g. The module implements transmit and receive functions at 850 nm wavelength and follows MSA-compatible mechanical and electrical specifications for seamless integration with network equipment that supports 10GBASE-SR transceivers.

Advantages

The module provides 10 Gbps data transmission in a compact SFP+ form factor with LC duplex connectivity. Its aluminium housing offers mechanical robustness and thermal dissipation while keeping the unit lightweight. The transceiver supports multimode fiber links up to typical short-range distances and includes digital diagnostic monitoring (DDM/DOM) capability when supported by the host hardware, allowing remote readout of parameters such as supply voltage, transmit power, receive power and temperature.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ port of a compatible switch, router or storage device by inserting the module until it clicks into place; follow the host vendor instructions for hot-swap handling and electrostatic discharge precautions. Connect LC duplex multimode fiber patch cords with correct polarity to the module’s LC connector. Verify link status in the host system and, if available, read digital diagnostic values through the device management interface to confirm operating parameters. For proper operation, ensure the host equipment officially supports 10GBASE-SR SFP+ transceivers and that the fiber type and patch cords match the short-range multimode specification.

Recommendations

Use OM3/OM4 multimode fiber and quality LC duplex patch cords for optimal range and performance. Confirm DDM/DOM compatibility with your host hardware before relying on real-time diagnostics. Avoid bending or stressing fiber connectors and follow ESD precautions during installation and removal.