Módulo transceptor de fibra óptica BlueOptics MT9102-BO 1250 Mbit/s LC

The BlueOptics MT9102-BO is an SFP fiber optic transceiver module designed for 1250 Mbit/s data transfer. It uses an LC interface and is intended for single-mode fiber links. The module is compact and lightweight (approximately 20 g) and meets CE, RoHS and FCC standards. The transceiver implements the 1000BASE-LX physical layer characteristics with 1310 nm transmit and receive wavelengths to support optical links up to several kilometers when used with appropriate single-mode fiber and patch cords.

Advantages

The module supports a standardized SFP form factor and LC duplex connector for broad compatibility with network switches, routers and storage systems that accept 1000BASE-LX SFP optics. Its compliance with CE, RoHS and FCC ensures conformity with common regulatory and safety requirements. The compact silver housing and low weight simplify installation and handling in dense rack environments. Where supported by the host device, the transceiver provides digital diagnostics (DDM/DOM) for real-time monitoring of key optical and electrical parameters.

Suitable for

Key specifications

How to use

Install the BlueOptics MT9102-BO by inserting the SFP module into an SFP slot on a compatible network device until it latches. Connect LC duplex single-mode patch cords to the module and the remote transceiver or patch panel, observing transmit/receive orientation. Ensure the host device supports 1000BASE-LX optics and, if you intend to use digital diagnostics, that the device supports DDM/DOM access. After insertion, verify link status on the host device and confirm negotiated speed and duplex where applicable.

Recommendations

Use single-mode fiber with appropriate attenuation and connectors to achieve the intended link distance; clean LC connectors before mating to avoid insertion loss. When replacing or installing transceivers in production equipment, power down or follow hot-swap guidance from the hardware vendor and verify firmware compatibility with third-party SFP modules if required.