Módulo transceptor de fibra óptica BlueOptics N-SM1310-PLUS-BO SFP+ LC aluminio 20g

The BlueOptics N-SM1310-PLUS-BO SFP+ LC Aluminium 20g is a single‑mode 10GBASE‑LR fiber optic transceiver module in an SFP+ form factor. It features an LC duplex interface and an aluminum housing with a lightweight design (approx. 20 g). The module transmits and receives at 1310 nm and is intended for high‑speed optical links up to 10 Gbit/s over single‑mode fiber, providing a compact option for switches, routers and storage systems that accept SFP+ modules.

Advantages

The module complies with SFP+ MSA mechanical and electrical specifications and is compatible with hardware platforms that support 10GBASE‑LR transceivers. Its aluminum housing offers mechanical durability and thermal stability while keeping weight low. Built to work with single‑mode fiber and LC duplex connectors, the transceiver supports bidirectional optical transmission and is suitable for standard Ethernet, Fibre Channel over Ethernet or SDH/SONET applications up to 10 Gbit/s. Digital diagnostics (DDM/DOM) support is provided where the host device implements the feature, enabling remote monitoring of supply voltage, laser bias current, optical output/input power and temperature.

Suitable for

Key specifications

How to use

Install the transceiver into an available SFP+ port on a compatible switch, router or storage device until it latches. Connect LC duplex single‑mode fiber patch cords to the module, observing transmit/receive orientation. Ensure the host device recognizes SFP+ 10GBASE‑LR modules and that any required firmware settings permit third‑party transceivers. Monitor the link status via the host device management interface and, if supported, read DDM/DOM parameters for operational diagnostics. When removing the module, power down the port if recommended by the hardware vendor or follow hot‑swap procedures specified for your equipment.

Recommendations

Use quality single‑mode LC patch cords and proper fiber handling to achieve the specified range and signal quality. Verify compatibility with the target hardware platform and enable DDM/DOM in the host when remote diagnostics are needed. Store and operate the transceiver within the environmental limits of the host device and follow anti‑static precautions during installation and removal.