Módulo transceptor de fibra óptica BlueOptics NPA0012-S011-BO 1250 Mbit/s SFP

The BlueOptics NPA0012-S011-BO fiber optic transceiver module is an SFP (Small Form-factor Pluggable) solution designed for 1.25 Gbit/s optical Ethernet links over multimode fiber. The module is silver in color, weighs approximately 20 g and follows industry standards for compact hot-pluggable transceivers. It implements LC duplex optical connections and supports optical transmission and reception at 850 nm for 1000Base-SX multimode links. The module meets CE, RoHS and FCC compliance requirements and is intended for reliable network connectivity in standard hardware platforms.

Advantages

The BlueOptics NPA0012-S011-BO offers compatibility with standard SFP interfaces and adheres to MSA guidelines, providing interoperable performance with switches, routers and storage systems that accept 1000Base-SX SFPs. It supports simultaneous transmit and receive operation via LC duplex connectors and is built using industrial-grade optical and electronic components to ensure long service life and stable optical performance. The module also supports digital diagnostics (DDM/DOM) where supported by the host device, enabling real-time monitoring of parameter values such as optical power and temperature.

Suitable for

Key specifications

How to use

Install the BlueOptics NPA0012-S011-BO module into an SFP slot of a compatible switch, router or other network device while the device is powered according to the host vendor’s hot-swap guidelines. Connect LC duplex multimode fiber patch cables to the module’s LC receptacle, ensuring correct transmit/receive orientation. Verify link status and speed on the host device and, if available, read DDM/DOM parameters through the management interface to confirm optical power and temperature are within expected ranges. Follow the host equipment manufacturer’s instructions for any required configuration or firmware compatibility checks.

Recommendations

Use multimode fiber cabling rated for 850 nm (OM1/OM2/OM3/OM4 as appropriate) and LC duplex patch cords from reliable manufacturers to achieve the specified short-range performance. Confirm host device compatibility with 1000Base-SX SFP modules and enable DDM/DOM only when the host supports it. Avoid bending the fiber near the transceiver and maintain proper ESD precautions during installation and removal.