Módulo transceptor de fibra óptica BlueOptics ONS-SC-GE-LX=2-BO 1250 Mbit/s LC

The BlueOptics ONS-SC-GE-LX=2-BO fiber optic transceiver module is a single‑mode SFP designed for optical data transmission at rates up to 1250 Mbit/s. It features an LC duplex interface in a compact silver housing and is compliant with CE, RoHS and FCC standards. With a lightweight design of 20 g, this module is intended for use in networking equipment that supports MSA‑compliant SFP modules and 1000BASE‑LX optical links.

Advantages

The module provides stable optical link performance over single‑mode fiber with 1310 nm transmitter and receiver wavelengths compatible with 1000BASE‑LX applications. Compliance with common regulatory standards ensures basic environmental and safety conformity, while the LC interface and SFP form factor support easy hot‑swap installation in compatible switches, routers and storage devices. Its compact size and low weight simplify handling and mounting in dense equipment racks.

Suitable for

• Establishing 1.25 Gbit/s Ethernet links over single‑mode fiber (1000BASE‑LX)
• Connecting switches, routers and storage systems with LC fiber connections
• Extending optical links up to typical LX distances in enterprise and carrier networks
• Replacement or upgrade of MSA‑compliant SFP ports in compatible hardware

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Data rate: up to 1250 Mbit/s
• Fiber type: single‑mode fiber
• Wavelength: 1310 nm (transmit and receive)
• Connector: LC duplex
• Weight: 0.02 kg
• Housing colour: silver
• Standards: CE, RoHS, FCC compliant

How to use

Insert the transceiver into an empty SFP slot of a compatible switch, router or storage device while the host is powered according to the equipment manual. Connect an LC duplex single‑mode fiber patch cable ensuring correct polarity between transmit and receive fibers. Verify link status in the host equipment and, if supported, enable Digital Diagnostic Monitoring (DDM/DOM) to monitor real‑time parameters such as optical power and temperature through the host management interface.

Recommendations

Use high‑quality single‑mode LC patch cords and adhere to the host vendor’s compatibility list when available. Ensure fiber connectors are clean and avoid sharp bends in the fiber run. If DDM/DOM telemetry is required, confirm that the host hardware and firmware support these diagnostics for remote monitoring.