Módulo transceptor de red BlueOptics 10G-XFP-LR-AL-BO 10000 Mbit/s XFP

The BlueOptics 10G-XFP-LR-AL-BO network transceiver module is a fiber optic XFP interface module designed for 10 Gbit/s network links. Its compact XFP form factor and silver finish make it compatible with equipment that accepts XFP modules. The module supports a maximum data transfer rate of 10000 Mbit/s and is built to achieve a high mean time between failures (MTBF) of 1,000,000 hours. Compliance with CE, FCC and RoHS standards ensures it meets common regulatory and environmental requirements for deployment in enterprise and service provider networks.

Advantages

The module offers a standardized XFP interface for straightforward insertion into compatible transceiver slots and supports full 10 Gbit/s throughput for high-bandwidth connections. Its high MTBF provides predictable reliability for continuous operation, while CE, FCC and RoHS compliance simplifies regulatory acceptance. The compact physical dimensions and low weight make it suitable for dense hardware installations where space and weight are factors.

Suitable for

• 10 Gbit/s fiber backbone links between switches and routers
• Metro and campus networks requiring XFP compatibility
• Data center uplinks and aggregation ports
• Network equipment replacement or spare parts stock

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: XFP-compatible transceiver
• Product colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Ensure the host device supports XFP transceivers and is powered down or in a state recommended by the equipment vendor for module insertion. Carefully insert the BlueOptics 10G-XFP-LR-AL-BO into the appropriate XFP slot until it seats firmly, and secure any retention mechanism the chassis provides. Connect the compatible fiber optic cable and verify link status using the host device management interface. Follow the network equipment manufacturer's guidelines for hot-swap procedures if inserting or removing the module while the system is powered.

Recommendations

Use single-mode fiber and connectors that match the transceiver and your network design. Maintain clean connector end-faces and follow ESD handling precautions when installing or removing the module. Verify that transceiver firmware and host equipment support the 10 Gbit/s XFP module and monitor link status after installation to confirm proper operation.