Módulo transceptor QSFP BlueOptics QSFP-100G-DR-BO 100000 Mbit/s

The BlueOptics QSFP-100G-DR-BO is a QSFP28 fiber optic transceiver module engineered for 100 Gbit/s data transmission over single‑mode fiber. It uses an LC duplex connector and supports optical links up to 500 m, making it suitable for data center interconnects and high‑performance network equipment. The module is silver in colour, lightweight (approximately 50 g) and conforms to MSA QSFP28 form‑factor characteristics for straightforward installation in compatible ports.

Advantages

The module provides a consistent 100000 Mbit/s throughput and a standardized QSFP28 interface for broad compatibility with modern switches, routers and storage systems. Its LC duplex connector and single‑mode optical design minimize electromagnetic interference and enable bidirectional laser transmission. Built to MSA form‑factor guidelines, the transceiver supports digital diagnostics monitoring where supported by host hardware, enabling real‑time monitoring of supply voltage, laser bias current, output/input optical power and temperature for easier maintenance and troubleshooting.

Suitable for

Key specifications

How to use

Insert the QSFP-100G-DR-BO module into a compatible QSFP28 port on the switch, router or storage device until it latches. Connect LC duplex single‑mode fiber patch cords between transceivers or to patch panels, ensuring correct transmit/receive orientation. Verify link status in the host device and, if supported, read digital diagnostics monitoring (DDM/DOM) values through the host interface to confirm operating parameters. Follow the host equipment vendor instructions for hot‑swap procedures and safe handling to avoid damage to the optical interface.

Recommendations

Use high‑quality single‑mode LC patch cords and maintain clean fiber endfaces to preserve link performance. Ensure the host device supports QSFP28 modules and DDM/DOM if you need diagnostic telemetry. For longest service life, avoid excessive bending of fiber and store unused modules in protective covers when not installed.