Módulo transceptor SFP BlueOptics 02317348-BO 1250 Mbit/s fibra óptica

The BlueOptics 02317348-BO is a fiber optic SFP transceiver module designed for single-port network equipment requiring a compact, hot-pluggable optical interface. With a maximum data transfer rate of 1250 Mbit/s and an SFP form factor, this silver-coloured module provides an industry-standard optical connection for switches, routers and media converters. The module's lightweight construction (approximately 20 g) and a mean time between failures (MTBF) rating of 1,000,000 hours indicate a balance of portability and operational reliability, while compliance with CE, FCC and RoHS standards ensures conformity with common regulatory requirements.

Advantages

The SFP transceiver offers an established physical interface compatible with a wide range of networking devices that support SFP modules. Its 1250 Mbit/s rated throughput supports typical gigabit and legacy link scenarios where 1.25 Gbps optical links are required. The compact SFP form factor and low weight simplify installation and hot-swap replacement without powering down equipment. Regulatory compliance reduces integration concerns for deployments in environments that require CE, FCC and RoHS conformity. A long MTBF provides predictable service life for planning maintenance and replacements.

Suitable for

• Upgrading or extending fiber links between switches and routers
• Use in media converters and uplink ports of network appliances
• Environments that need compact, hot-pluggable optical interfaces
• Replacement of existing SFP optical transceivers in compatible hardware

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Product colour: Silver
• Weight: 0.02 kg (approx.)
• Mean time between failures (MTBF): 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Insert the BlueOptics SFP transceiver into a compatible SFP slot on your switch, router or media converter until it seats and the retention latch engages. Connect the appropriate fiber optic cable to the transceiver's optical interface, observing correct connector type and polarity for your network (ensure clean connectors to avoid signal loss). The module is hot-pluggable; most devices will detect the transceiver and negotiate link parameters automatically. Monitor link status via the host device's management interface and follow the equipment manufacturer's guidance for any required configuration or testing procedures.

Recommendations

Use clean, appropriately rated fiber optic cables and dust caps when the transceiver is not connected. Verify compatibility with your host device's supported SFP modules and optical specifications before deployment. For reliable operation, perform periodic inspection of connectors and follow your network's maintenance schedule.