Módulo transceptor SFP+ BlueOptics 100-01511-BX40-U-BO 10000 Mbit/s

The BlueOptics 100-01511-BX40-U-BO is an SFP+ transceiver module designed for 10 Gigabit Ethernet fiber connections. It supports a maximum data transfer rate of 10000 Mbit/s and is built in a compact SFP+ form factor that fits standard hot-pluggable ports. The module uses an LC (UPC) fiber optic connector and supports a maximum transfer distance of up to 40,000 meters, offering a lightweight solution at approximately 0.02 kg and an MTBF of 1,000,000 hours for sustained operation in network environments.

Advantages

This SFP+ transceiver provides a balance of high-speed performance and compact design suitable for modern network infrastructures. The 10 Gigabit Ethernet interface enables high-throughput data transfer while the LC (UPC) connector ensures reliable optical coupling. The module's silver housing and SFP+ form factor facilitate easy installation and compatibility with a wide range of switches and transceivers. A long MTBF of 1,000,000 hours indicates a low likelihood of failure during continuous use.

Suitable for

• High-speed data links between switches and routers
• Long-distance fiber optic connections up to 40 km
• Data center uplinks and server connections
• Enterprise backbone and aggregation links

Key specifications

• Maximum data transfer rate: 10000 Mbit/s
• Maximum transfer distance: 40000 m
• Ethernet interface type: 10 Gigabit Ethernet
• Fiber optic connector: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Form factor: SFP+
• Reliability (MTBF): 1,000,000 hours

How to use

Install the BlueOptics SFP+ transceiver into a compatible SFP+ slot on your switch, router, or media converter while the device is powered off or following the hot-plug guidance of the host equipment. Connect a suitable single-mode or multimode fiber cable with LC (UPC) connectors to the transceiver ports, ensuring correct polarity and clean connector end-faces. Configure the network device for 10 Gigabit Ethernet operation as required by your network setup and verify link status through the host device's management interface.

Recommendations

Maintain clean fiber connectors by using appropriate cleaning tools before insertion, avoid bending the fiber beyond its minimum bend radius, and use compatible host hardware that supports SFP+ 10 Gigabit modules. For long-distance runs, verify fiber type and attenuation to ensure reliable operation up to the specified 40 km range.