Módulo transceptor SFP BlueOptics 100-01957-BO 1250 Mbit/s

The BlueOptics 100-01957-BO 1250 Mbit/s SFP transceiver module is a compact fiber-optic interface designed for insertion into SFP ports on network switches, routers and media converters. It provides a maximum data transfer rate of 1250 Mbit/s and comes in a silver metal housing. The module is built for long service life with a mean time between failures (MTBF) of 1,000,000 hours and meets CE, FCC and RoHS compliance requirements.

Advantages

The SFP transceiver offers a small form factor suitable for hot-pluggable use, allowing quick replacement or upgrades without powering down equipment. Its 1250 Mbit/s-rated link supports standard fiber connections used in many access and aggregation scenarios. The silver housing provides mechanical protection and heat dissipation, while compliance with international directives ensures compatibility with regulatory and environmental requirements.

Suitable for

• Fiber uplinks between switches and routers
• Connecting media converters to fiber networks
• Replacing or expanding SFP ports in enterprise and small business equipment
• Short- to medium-distance multimode or single-mode fiber links (depending on matching fiber specification)

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Housing colour and material: silver metal housing
• Weight: 0.02 kg
• Reliability: MTBF approximately 1,000,000 hours
• Compliance: CE, FCC, RoHS

How to use

Ensure compatible fiber type and connector match the transceiver specifications before installation. Power down or follow the hot-swap procedure recommended by your equipment vendor, insert the SFP module into an available SFP slot until it latches, and then connect the appropriate fiber patch cable. Verify link status and configure port settings on the switch or router as required by your network design. Follow vendor documentation for LED indicators and diagnostics.

Recommendations

Store and install the module in a clean, dry environment. Use dust caps on the transceiver and fiber connectors when not in use, and avoid touching optical interfaces. Match transmit and receive wavelengths and fiber type between link endpoints to ensure proper operation. For critical deployments, verify compatibility with the host device and test link performance after installation.