Módulo transceptor SFP BlueOptics 100-04064-BO 1250 Mbit/s fibra óptica

The BlueOptics 100-04064-BO SFP transceiver module is a compact fiber optic interface designed for network devices that require a 1.25 Gigabit Ethernet link with a maximum data transfer rate of 1250 Mbit/s. Housed in a silver metal enclosure and weighing 20 g, this module supports single-mode fiber connections via an LC (UPC) connector and is rated for link distances up to 40,000 m. With a published mean time between failures (MTBF) of 1,000,000 hours, the module is intended to provide stable optical connectivity in switches, routers and media converters.

Advantages

The module’s small form-factor pluggable design allows hot-swappable installation without interrupting device operation, while the LC (UPC) connector ensures precise optical alignment and low insertion loss. Its single-mode reach of up to 40 km supports long-distance links and backbone connections. The lightweight, silver metal housing provides mechanical protection and electromagnetic shielding, and the high MTBF value reflects reliable service life for continuous network deployments.

Suitable for

• Long-distance single-mode fiber links between network sites
• 1.25 Gigabit Ethernet uplinks in switches and routers
• Media converters and optical line cards requiring LC (UPC) interfaces
• Fiber-based backbone and campus network segments

Key specifications

• Maximum data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 40,000 m (40 km)
• Ethernet interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber optic connector: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours

How to use

Power down the host device only if the manufacturer requires it; otherwise, insert the SFP transceiver into an appropriate SFP slot until it seats firmly and latches. Connect a single-mode fiber cable with LC (UPC) connectors to the module and route the fiber to the remote endpoint following standard fiber handling practices to avoid bends and contamination. Configure the host device’s interface settings (speed, duplex, and optical diagnostics) as needed and verify link status through the device management interface or LEDs.

Recommendations

Prioritize clean connector endfaces by inspecting and cleaning LC connectors before mating to minimize optical loss. Use single-mode fiber rated for long-distance links and maintain bend-radius guidelines. Check compatibility with the host device’s SFP support list and verify transceiver firmware or vendor interoperability notes when integrating into heterogeneous networks.