Módulo transceptor SFP+ BlueOptics JW091A-BO 10000 Mbit/s 850 nm

The BlueOptics JW091A-BO SFP+ transceiver module is designed for 10 Gigabit optical links over multimode fiber. It supports a maximum data rate of 10000 Mbit/s, uses an LC duplex fiber connector and operates at an 850 nm wavelength. The compact silver metal housing and lightweight design (approximately 20 g) make the module suitable for mounting in compatible SFP+ ports while meeting CE and RoHS compliance requirements.

Advantages

This SFP+ transceiver delivers 10GBASE-SR performance with support for simultaneous transmit and receive on separate fibers via the LC connector. Compliance with common MSA electrical and mechanical specifications ensures interoperability with a wide range of network switches, routers and storage platforms that accept SFP+ modules. The module’s small form factor and low weight simplify installation and cabling in rack environments. Built to industry standards, it provides a predictable optical link behavior for short-reach multimode applications.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ port until it locks in place, then connect LC duplex multimode fiber patch cords to the transmit and receive ports. Ensure the host device supports 10GBASE-SR modules and, if required, enable or verify link settings in the network equipment management interface. For initial bring-up, verify link integrity and optical power levels according to the connected hardware’s diagnostics.

Recommendations

Use OM3/OM4 multimode fiber patch cords for optimal reach and performance at 10 Gbit/s, and verify that the connected switch or router supports digital diagnostics (DDM/DOM) if remote monitoring of optical parameters is required. Follow manufacturer guidelines for hot-plugging and electrostatic discharge (ESD) precautions when handling the transceiver.