Módulo transceptor SFP+ BlueOptics 10GB-LRM-SFPP-BO 10000 Mbit/s

The BlueOptics 10GB-LRM-SFPP-BO is an SFP+ fiber optic transceiver module designed for single-mode and multimode links that require a 10 Gbit/s connection. The module supports a maximum data transfer rate of 10000 Mbit/s and fits standard SFP+ ports, providing a compact silver-bodied form factor with a weight of approximately 20 g. Built to industry compliance standards (CE, FCC, RoHS) and designed with a long mean time between failures (MTBF) of 1,000,000 hours, this transceiver addresses common connectivity requirements in data centers, enterprise networks, and telecommunications environments.

Advantages

The SFP+ transceiver offers a high data rate compatible with 10 Gbit/s ports while keeping a small SFP+ form factor that simplifies installation and hot-swap replacement. Its silver housing and standardized connector ensure physical compatibility and mechanical stability in network equipment. Compliance with CE, FCC and RoHS provides assurance of regulatory conformance and environmental safety, and the long MTBF contributes to reduced maintenance frequency and predictable lifecycle behaviour.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Server-to-switch connections in data centers
• Fiber backbone links within enterprise LANs
• Telecom and carrier edge interfaces that use SFP+ ports

Key specifications

• Form factor: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Interface type: SFP+
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Insert the BlueOptics SFP+ transceiver into a compatible SFP+ port on your switch, router or network card while the device is powered down or follow the vendor's hot-swap instructions if supported. Connect the appropriate fiber optic cable to the transceiver's LC connector according to the link type (single-mode or multimode) and ensure correct polarity and cleanliness of fiber endfaces. Configure the network device interface for 10 Gbit/s operation if manual configuration is required, then verify link status and perform any necessary diagnostic tests.

Recommendations

To ensure reliable operation, use matched fiber types and quality LC patch cords, keep connector endfaces clean using proper fiber cleaning tools, and verify compatibility with the host device's SFP+ port. Avoid mechanical stress on the transceiver and cabling, observe ESD precautions during handling, and follow vendor firmware and configuration guidelines for optimal performance.