Módulo transceptor SFP BlueOptics 15454-SFP-LC-SX-BO 1250 Mbit/s

The BlueOptics 15454-SFP-LC-SX-BO is an SFP transceiver module designed for short-range fiber optic connections. It supports a maximum data transfer rate of 1250 Mbit/s and uses the SFP form factor with an LC connector interface, intended for compatibility with a wide range of switches, routers and optical equipment. The module is finished in a silver housing and has a compact lightweight design. Certified to CE, FCC and RoHS standards and specified with an MTBF of 1,000,000 hours, it provides a predictable operational profile for network installations.

Advantages

The module provides straightforward integration into SFP-compatible ports and supports standard 1250 Mbit/s serial optical links. Its compact SFP form factor and low weight allow easy handling and hot-plug deployment in dense rack environments. Compliance with CE, FCC and RoHS indicates adherence to electromagnetic, safety and environmental requirements. The specified MTBF gives an estimate of long-term reliability for planned network uptime.

Suitable for

• Short-range multimode fiber connections in local area networks
• Replacing or upgrading existing SFP ports on switches and routers
• Hot-plug installations where compact transceivers are required
• Network setups requiring CE, FCC and RoHS compliant optical modules

Key specifications

• Interface type: SFP with LC connector compatibility
• Maximum data transfer rate: 1250 Mbit/s
• Form factor: small form-factor pluggable (SFP)
• Product colour: silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Compliance: CE, FCC, RoHS

How to use

Insert the BlueOptics SFP transceiver into an available SFP port on the network device until it latches. Connect the LC fiber patch cable to the module, observing correct Tx/Rx orientation for the link. After physical installation, verify link status through the device management interface and configure the port parameters as required for 1250 Mbit/s operation. For hot-pluggable changes, follow the device vendor guidelines to avoid transient link disruptions.

Recommendations

Install and remove the transceiver with the host device powered per vendor instructions when possible. Use multimode fiber and LC patch cords appropriate for SX short-range optics, keep fiber connectors clean to maintain signal quality, and monitor link statistics to confirm stable operation.