Módulo transceptor SFP BlueOptics 1KGT038901R0001-BO 155 Mbit/s

The BlueOptics 1KGT038901R0001-BO 155 Mbit/s is an SFP transceiver module designed for fiber optic network links. It supports a maximum data transfer rate of 155 Mbit/s and uses the SFP form factor for compatibility with a wide range of switches, routers and media converters. The module is finished in silver, weighs approximately 20 g and is intended for installation in devices with SFP ports. Compliance with CE, FCC and RoHS standards and a specified mean time between failures (MTBF) of 1,000,000 hours indicate industry-standard safety and reliability characteristics.

Advantages

This BlueOptics SFP transceiver provides a compact, hot-pluggable solution for fiber connections that require up to 155 Mbit/s throughput. The standardized SFP form factor ensures broad device compatibility and straightforward replacement or upgrade. A small physical footprint and lightweight housing make it easy to handle and install, while the declared MTBF and conformity to CE, FCC and RoHS reduce concerns about regulatory compliance and expected operational longevity.

Suitable for

• Connecting fiber links between switches, routers and media converters
• Legacy and low-bandwidth optical networks requiring 155 Mbit/s
• Environments where compact, hot-pluggable transceivers are needed

Key specifications

• Interface type: SFP
• Maximum data transfer rate: 155 Mbit/s
• Form factor: SFP transceiver module
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Install the transceiver into an available SFP port on the network device until it clicks into place, then connect the appropriate fiber optic cable and secure any cable retention if present. Ensure the device is powered and that port configuration matches the network settings and link speed requirements. For removal, power down or disable the port according to the host device instructions if required, then press the release mechanism and gently withdraw the module.

Recommendations

Verify that the host device supports third-party SFP modules and that link parameters are set to accommodate a 155 Mbit/s link. Handle the module by its housing, avoid touching the fiber connector endface, and keep dust caps in place when not connected. Store the module in a clean, dry environment and follow the host equipment vendor guidelines for hot-plugging and firmware compatibility.