Módulo transceptor SFP BlueOptics 1KGT038919R0001-BO 1250 Mbit/s

The BlueOptics 1KGT038919R0001-BO is an SFP transceiver module for fiber optic connections, supporting a maximum data transfer rate of 1250 Mbit/s. Its compact SFP form factor and silver finish make it suitable for integration into compatible switches and routers where space is limited. The module is designed for long-term operation with a stated mean time between failures (MTBF) of 1,000,000 hours and meets CE, FCC and RoHS compliance requirements for safe deployment in network environments.

Advantages

This SFP transceiver provides a standardized small form-factor interface for easy hot-plug installation and replacement. The 1250 Mbit/s data rate supports common telecom and networking links, while the high MTBF indicates low failure frequency and reduced maintenance intervals. Compliance with CE, FCC and RoHS ensures electromagnetic compatibility and adherence to environmental and safety regulations.

Suitable for

• Fiber optic uplinks between switches and routers
• Access and distribution links in enterprise LANs
• Telecommunications equipment requiring 1250 Mbit/s SFP modules
• Environments where compact SFP modules with low weight are needed

Key specifications

• Interface type: SFP small form-factor pluggable
• Maximum data transfer rate: 1250 Mbit/s
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Compliance: CE, FCC, RoHS

How to use

Install the BlueOptics SFP module into a compatible SFP slot on a switch, router or other networking device while the host device is powered down or following hot-plug guidance from the equipment manufacturer. Connect appropriate fiber optic patch cables to the module’s optical port, ensuring correct fiber type and connector compatibility. Verify link status and configure the host device port settings as required for the intended network speed and duplex mode.

Recommendations

Use certified single-mode or multimode fiber and connectors that match the transceiver’s specifications, follow electrostatic discharge (ESD) precautions during handling, and store unused modules in protective caps to prevent contamination of optical interfaces.