Módulo transceptor SFP BlueOptics 852-201-040-002-BO 155 Mbit/s

The BlueOptics 852-201-040-002-BO SFP transceiver module is a compact fiber-optic interface designed for network equipment that accepts SFP form-factor modules. Supporting a maximum data transfer rate of 155 Mbit/s, this silver-coloured module provides a standardized connection for single-mode or multimode fiber links (depending on the linked transceiver and cable). With a lightweight 20 g housing and industry-standard SFP footprint, the module is suitable for use in switches, routers and media converters that require an SFP port and 155 Mbit/s link speeds.

Advantages

The module follows common industry standards for SFP devices and carries CE, FCC and RoHS conformity, ensuring regulatory compliance for electromagnetic compatibility and material restrictions. A mean time between failures (MTBF) of 1,000,000 hours indicates long operational life under normal conditions. Its compact SFP form factor and low weight make it easy to handle and install in dense networking environments without significantly increasing rack load.

Suitable for

• Extending or establishing fiber connections at 155 Mbit/s between network devices
• Replacing or upgrading SFP ports in switches, routers or media converters that require 155 Mbit/s transceivers
• Laboratory and testing setups where standardized SFP modules are needed

Key specifications

• Form factor: SFP
• Maximum data transfer rate: 155 Mbit/s
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Power off the host device or follow hot-swap procedures supported by the equipment, then insert the SFP transceiver into an available SFP port until it seats securely. Connect the appropriate fiber patch cable to the transceiver’s optical interface, ensuring correct connector type and polarity for the chosen fiber. Configure the host device’s interface settings to match a 155 Mbit/s link rate and verify link status and diagnostics through the device management interface. If the host supports hot-plugging, follow vendor guidelines to avoid link flapping or configuration loss.

Recommendations

Use compatible fiber cables and transceiver types recommended by your network equipment vendor. Avoid exposing the optical interface to dust or direct sunlight; keep protective dust caps on when the module is not connected. Observe ESD precautions during handling and install the transceiver in accordance with the host device’s specifications to ensure reliable operation at 155 Mbit/s.