Módulo transceptor SFP+ BlueOptics AA076005 10000 Mbit/s 850 nm

The BlueOptics AA076005 SFP+ transceiver module provides a compact solution for 10 Gbit/s fiber connections over multimode fiber. It operates at a nominal wavelength of 850 nm, uses an SFP+ interface with an LC duplex connector and is supplied as an individually packaged, silver-coloured module weighing approximately 20 g. The module follows common MSA form-factor and electrical specifications for use in compatible switches, routers and storage equipment where 10G optical links are required.

Advantages

The module supports a maximum data rate of 10000 Mbit/s and is designed for short-range multimode fiber links using 850 nm optics. Its SFP+ form factor enables hot-pluggable installation in standard SFP+ ports. The small, lightweight metal housing provides mechanical stability and electromagnetic immunity typical for optical transceivers. The product is tested for interoperability with equipment that accepts standard SFP+ optical modules and is packaged individually for easy inventory and deployment.

Suitable for

• Short-range 10 Gbit/s links over multimode fiber in data centers
• Interconnects between switches, routers and servers with SFP+ ports
• High-bandwidth connections for storage and virtualization platforms
• Upgrading existing copper ports to optical SFP+ interfaces

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm (multimode fiber)
• Connector: LC duplex
• Module colour: Silver
• Weight: approximately 0.02 kg
• Form factor: hot-pluggable SFP+ optical transceiver

How to use

Insert the BlueOptics AA076005 SFP+ transceiver into a compatible SFP+ port on your network device while the device is powered according to the vendor guidelines for hot-pluggable modules. Connect LC duplex multimode fiber patch cables to the transceiver, ensuring correct transmit/receive orientation. Configure the host device network interface as required by your switch, router or server operating system and verify link status and negotiated speed through the device management interface. Follow standard handling procedures for electrostatic-sensitive devices and avoid touching optical interfaces to prevent contamination.

Recommendations

For optimal performance, use OM3/OM4 multimode fiber patch cables appropriate for 10 Gbit/s short-range links, keep connectors clean using proper cleaning tools, and confirm that the host hardware supports third-party SFP+ modules or is configured to accept them. Monitor link parameters via device diagnostics if supported and replace modules showing degraded optical power or error rates.