Módulo transceptor SFP BlueOptics AA1419081-E6 1250 Mbit/s 1310 nm

The BlueOptics AA1419081-E6 1250 Mbit/s 1310 nm is an SFP fiber optic transceiver module designed for single-mode optical links. It supports a data transfer rate up to 1250 Mbit/s and transmits at a wavelength of 1310 nm, providing a compact hot-pluggable solution for network devices with SFP interfaces. The module is intended for use in point-to-point connections where moderate-speed optical connectivity and reliable signal transmission are required.

Advantages

This SFP transceiver offers a standardized SFP form factor for broad compatibility with switches, routers and media converters that accept SFP modules. Operating at 1310 nm frequency, it is suitable for single-mode fiber links over intermediate distances. The module’s 1250 Mbit/s data rate supports common network protocols and provides stable optical performance with low power consumption. Its compact design enables easy installation and replacement without powering down network equipment.

Suitable for

• Single-mode fiber optic links in enterprise and access networks
• Interconnection between switches and routers using SFP ports
• Media converters and optical uplink ports in wiring closets and telecom racks
• Replacing or upgrading existing 1310 nm SFP transceivers

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1310 nm
• Fiber type: single-mode (SM)
• Hot-pluggable: yes

How to use

Insert the module into an available SFP slot on a compatible network device until it clicks into place. Connect a single-mode fiber patch cable with appropriate connectors (e.g., LC) to the module’s optical port, ensuring correct polarity. Configure the network device to recognise the transceiver and set the corresponding interface parameters according to the device’s management interface. Monitor link status LEDs on the host device to confirm successful connection.

Recommendations

Install and remove the transceiver only when guided by the device’s instructions and, where possible, during maintenance windows to avoid disrupting traffic. Use clean fiber connectors and follow proper handling procedures to prevent contamination and damage. Verify the host device compatibility and any required configuration for optical interfaces before deployment.