Módulo transceptor SFP+ BlueOptics AC-SFP+-MM-0082 10000 Mbit/s 850 nm

The BlueOptics AC-SFP+-MM-0082 is an SFP+ transceiver module designed for short-range multimode fiber links. It supports a maximum data transfer rate of 10000 Mbit/s and operates at an 850 nm wavelength. Housed in a compact SFP+ form factor with a silver finish, the module is lightweight at approximately 20 g and meets CE, FCC and RoHS compliance for compatibility with professional networking environments.

Advantages

This SFP+ transceiver provides reliable high-speed connectivity for data center and enterprise networks with a mean time between failures (MTBF) rating indicating long operational life. The 850 nm multimode design enables cost-effective short-range fiber connections while the compact SFP+ package simplifies installation into compatible switch and router ports. Compliance with industry regulations ensures interoperability and reduced environmental impact.

Suitable for

• Short-range multimode fiber links in data centers
• 10 Gigabit Ethernet connections between switches and servers
• High-density networking environments requiring SFP+ modules
• Upgrading existing multimode fiber infrastructure to 10 Gbit/s

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Optical wavelength: 850 nm (multimode)
• Form factor: SFP+
• Typical weight: 0.02 kg
• Housing colour: silver
• Compliance: CE, FCC, RoHS
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the module into a compatible SFP+ slot on a switch, router or network interface card following the equipment manufacturer’s hot-swap and handling guidelines. Connect the appropriate multimode fiber patch cable and verify link activity via the host device LEDs or management interface. Ensure polarity and connector type match the transceiver and fiber cable; support equipment should be configured for 10 Gbit/s operation if required.

Recommendations

Store and handle the transceiver in a clean, dry environment and avoid touching the optical connector endface. Use multimode fiber rated for 850 nm and test links after installation to confirm signal quality. Observe ESD precautions when handling the module and follow vendor guidance for firmware or compatibility notes when integrating with existing network hardware.