Módulo transceptor SFP+ BlueOptics BO55J33620D 10000 Mbit/s 1330 nm

The BlueOptics BO55J33620D SFP+ transceiver module is a compact optical interface designed for 10 Gigabit Ethernet links. Supporting a maximum data transfer rate of 10000 Mbit/s and operating at a wavelength of 1330 nm, this module enables high-speed fiber connections over single-mode fiber. The SFP+ form factor and 3.3 V input voltage make it compatible with a wide range of switches, routers and media converters. Compliance with CE, FCC and RoHS standards ensures regulatory conformity and environmental safety.

Advantages

The transceiver provides stable 10 Gigabit Ethernet performance with a maximum reach of up to 20,000 m over appropriate single-mode fiber, while maintaining a small SFP+ footprint that saves rack space. Its silver housing and lightweight construction (approximately 0.02 kg) simplify installation and handling. Industry-standard electrical and optical specifications allow straightforward hot-plug replacement and interoperability with compliant network equipment.

Suitable for

• Long-distance 10 Gigabit Ethernet links over single-mode fiber
• Interconnects between switches, routers and media converters
• Data center uplinks and aggregation ports
• Telecommunications and carrier access networks

Key specifications

• Data rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 1330 nm
• Maximum transfer distance: 20,000 m (single-mode fiber)
• Form factor: SFP+
• Operating voltage: 3.3 V
• Ethernet interface: 10 Gigabit Ethernet
• Colour: Silver
• Weight: 0.02 kg

How to use

Insert the SFP+ module into a compatible SFP+ slot on your switch, router or media converter until it clicks into place. Connect the appropriate single-mode fiber cable with matching connectors and ensure correct polarity and end-face condition. Configure the network device port for 10 Gigabit operation if required by firmware or management interface. Monitor link status indicators on the host device to confirm successful negotiation and optical link stability.

Recommendations

To achieve the specified maximum distance and stable performance, use single-mode fiber with suitable connectors and maintain clean connector end faces. Avoid excessive bending of fiber cables and follow ESD precautions during handling. Verify firmware compatibility and, if needed, consult the network equipment vendor for any required configuration or compatibility settings.