Módulo transceptor SFP+ BlueOptics BTI-SFP+-XBD10L-DD-27/33S-BO 10000 Mbit/s

The BlueOptics BTI-SFP+-XBD10L-DD-27/33S-BO 10000 Mbit/s is an SFP+ transceiver module for 10 Gigabit Ethernet applications over fiber. Designed with an LC fiber optic connector and a silver form factor, this compact module supports a maximum data transfer rate of 10,000 Mbit/s and link distances up to 10,000 m. With a rated mean time between failures (MTBF) of 1,000,000 hours and a lightweight construction of approximately 20 g, it is suitable for dense installation in switches, media converters and server network interfaces where small form-factor pluggable modules are required.

Advantages

The module provides high-speed 10 Gigabit connectivity in a standardized SFP+ package, supporting long-reach single-mode fiber links up to 10 km. Its compact silver housing and LC connector enable compatibility with equipment that accepts SFP+ transceivers, while the low weight and proven MTBF offer dependable operation and simplified inventory management. The product's straightforward physical design reduces installation complexity and enables flexible deployment in rack-mounted and compact network devices.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures for your network equipment according to the manufacturer's instructions before installing the transceiver. Align the module with the SFP+ cage and gently insert until it latches; connect LC fiber patch cords to the transmitter and receiver ports, ensuring correct polarity. After installation, verify link status and configure the device's network interface as required for 10 Gigabit operation. To remove, release the latch and pull the module straight out, then protect the optical ports with dust caps when not in use.

Recommendations

Use single-mode LC patch cords matched to the transceiver specifications and maintain clean fiber end-faces to prevent signal loss. Observe ESD precautions when handling the module and avoid mechanical stress on the fiber. For reliable long-term operation, install the transceiver in equipment that supports SFP+ modules and confirm compatibility with the host device's firmware and optical budgets.