Módulo transceptor SFP BlueOptics GXVR-LX-20-BO 1250 Mbit/s

The BlueOptics GXVR-LX-20-BO 1250 Mbit/s SFP transceiver module is a compact fiber optic interface designed for single-mode links. Built in an SFP form factor with an LC duplex connector and a silver housing, this module supports up to 1250 Mbit/s data rate and a maximum transmission distance of 20,000 meters. Weighing approximately 0.02 kg, the module is lightweight and intended for simple installation in compatible networking equipment that accepts standard SFP transceivers.

Advantages

This transceiver follows MSA-compliant SFP sizing and uses LC duplex fiber connectivity to enable simultaneous transmit and receive channels. It supports common high-speed protocols up to 1.25 Gbit/s and is suitable for single-mode fiber links up to 20 km. The module is manufactured to industry component standards and is designed for long operational life and stable optical performance in a range of network hardware that accepts compatible SFP optics.

Suitable for

Key specifications

How to use

Power off or follow hot-swap procedures for your networking equipment according to the vendor instructions, then insert the SFP module into a compatible SFP slot until it seats firmly. Connect LC duplex single-mode fiber patch cords to the module, observing correct TX/RX orientation. Confirm link status via the host device interface and verify that the port negotiates the expected data rate and protocol. If the device supports digital diagnostics (DDM/DOM), enable and read the available monitoring values through the host management interface.

Recommendations

Use high-quality single-mode LC duplex patch cords and, where applicable, patch panels to achieve optimal range and signal integrity. Ensure your host hardware supports 1.25 Gbit/s SFP modules and, if you require remote monitoring of optical parameters, verify that the platform supports DDM/DOM functionality.