Módulo transceptor SFP+ BlueOptics J9150DR 10000 Mbit/s 850 nm

The BlueOptics J9150DR is an SFP+ transceiver module designed for short-range fiber optic links with a maximum data transfer rate of 10000 Mbit/s. Operating at an 850 nm wavelength, it is intended for use in data centers, server rooms and enterprise network environments where high-throughput, low-latency connections are required. The module follows the SFP+ form factor and provides a standardized interface for integration with compatible switches, routers and NICs.

Advantages

The module offers reliable high-speed performance for short-reach multimode fiber connections and supports a 10 Gbps data rate to handle demanding traffic loads. Its SFP+ interface ensures broad compatibility with equipment that accepts SFP+ transceivers, simplifying installation and replacement. The 850 nm wavelength is optimized for typical multimode fiber runs in racks and between adjacent equipment in data center topologies.

Suitable for

• 10 Gbps short-range links in data centers
• Server-to-switch and switch-to-switch uplinks
• High-speed connections in campus and enterprise LANs
• Multimode fiber cabling within racks and between adjacent racks

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Wavelength: 850 nm
• Typical application: short-range multimode fiber links

How to use

Insert the BlueOptics J9150DR transceiver into a compatible SFP+ port on the network device until it clicks into place. Connect the appropriate multimode fiber patch cable (LC connectors commonly used) between transceivers at each end of the link, ensuring correct polarity. Verify link status via the host device interface and monitor for expected 10 Gbps operation. When removing the module, power down or disable the port if recommended by the equipment vendor, then press the release mechanism and slide the transceiver out straight to avoid damage.

Recommendations

Use the transceiver with multimode fiber rated for short-range 850 nm operation, keep fiber connectors clean to maintain link quality, and confirm compatibility with your switch or host vendor before deployment to ensure full functionality at 10 Gbps.