módulo transceptor SFP BlueOptics MCSEAAF1LFU00-BO 155 Mbit/s

The BlueOptics MCSEAAF1LFU00-BO is an SFP transceiver module for fiber optic connections with a maximum data transfer rate of 155 Mbit/s. Built in an SFP form factor and finished in silver, the module supports LC duplex multimode fiber connections and follows common MSA form-factor conventions to ensure interoperability with networking equipment that accepts SFP modules. The transceiver includes both transmit and receive functions operating at 1310 nm and is specified with a high mean time between failures (MTBF) for reliable continuous operation. Its compact and lightweight design makes it easy to handle and install in switches, routers and other compatible hardware.

Advantages

The module provides a standardized SFP form factor that enables hot-pluggable installation and compatibility with a wide range of networking devices. With a maximum transfer rate of 155 Mbit/s and LC Duplex multimode fiber connectivity, it supports established 100BASE-FX style fiber links while maintaining low weight and compact dimensions for straightforward mounting and transportation. The specified MTBF contributes to predictable operational availability in network deployments.

Suitable for

Key specifications

How to use

Before installation, ensure the host device supports SFP transceivers and the intended data rate and optical interface. With the host powered down or following the equipment vendor's hot-swap instructions, insert the SFP module into an available SFP slot until it latches. Connect LC duplex multimode fiber patch cords to the module’s connectors, observing correct Tx/Rx orientation. After installation, verify link status and configure the host device’s port settings as required for the desired link speed and protocol.

Recommendations

Use certified multimode LC duplex fiber patch cords and keep protective caps on the transceiver when not connected. Follow equipment vendor guidance on compatibility and any required firmware or port configuration. Avoid exposure to excessive dust, moisture or mechanical stress to preserve optical performance and service life.