Módulo transceptor SFP BlueOptics RED-SFP-GE-ZX-BO 1250 Mbit/s 1550 nm

The BlueOptics RED-SFP-GE-ZX-BO is an SFP transceiver module designed for single-mode fiber optic links. It supports a data transfer rate up to 1250 Mbit/s and operates at a wavelength of 1550 nm. Housed in a compact SFP form factor with an LC duplex connector and a lightweight silver enclosure (approx. 20 g), this module enables long-reach optical connections up to 80,000 m and is intended for use in switches, routers and other network devices that accept standard SFP modules.

Advantages

The module follows MSA-compatible SFP specifications and provides optical transmit and receive functions at 1550 nm for reliable long-distance links. With a mean time between failures (MTBF) of approximately 3,000,000 hours and a design that uses quality optical and electronic components, it delivers stable performance and long service life. The LC duplex interface and compact SFP form factor make the transceiver easy to install and replace in standard networking hardware.

Suitable for

Key specifications

How to use

Ensure the host device supports MSA-compliant SFP modules and, if required, DDM/DOM functions. Power down or follow hot-swap procedures for your hardware as specified by the device manufacturer before inserting the transceiver into an SFP slot. Connect LC duplex single-mode fiber patch cables to the module, observing correct TX/RX orientation. Configure the host interface for the intended protocol (for example 1000BASE-ZX or the supported Gigabit Ethernet mode) and verify link status through the device management interface.

Recommendations

Use high-quality single-mode LC patch cables and, where possible, test fiber end-face cleanliness before connection. Verify that the network equipment supports 1550 nm optics and DDM/DOM if remote diagnostics are required. Follow ESD precautions during handling and store spare transceivers in protective packaging to preserve optical performance.