Módulo transceptor SFP BlueOptics SFP-1000BASE-SXLEG 1250 Mbit/s 850 nm

The BlueOptics SFP-1000BASE-SXLEG 1250 Mbit/s 850 nm is a small form-factor pluggable fiber optic transceiver module designed for gigabit networking. It supports a maximum data transfer rate of 1250 Mbit/s over multimode fiber using an 850 nm wavelength. The module's compact SFP interface makes it compatible with a wide range of switches, routers and network devices that accept SFP transceivers, enabling simple upgrades or replacements in existing infrastructure.

Advantages

This SFP transceiver provides reliable optical connectivity with a standardized SFP form factor and an 850 nm optical interface suited for short-reach multimode links. Its data rate of 1250 Mbit/s ensures compatibility with gigabit Ethernet systems while keeping power consumption and footprint low. The module is engineered for plug-and-play installation, allowing quick deployment and minimal configuration effort.

Suitable for

• Gigabit Ethernet connections over multimode fiber for short distances
• Upgrading or replacing SFP ports on switches and routers
• Data center and enterprise network links where 850 nm short-reach optics are required
• Patch panels and fiber distribution frames using SFP modules

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Optical wavelength: 850 nm for multimode fiber
• Application: Short-reach multimode fiber links
• Form factor: Hot-pluggable SFP module

How to use

Install the BlueOptics SFP-1000BASE-SXLEG by inserting the module into an available SFP slot on a compatible switch, router or transceiver cage until it clicks into place. Connect the multimode fiber patch cable with appropriate connectors to the optical port and secure the cable to avoid strain on the connector. After physical installation, verify link status on the network device and configure interface settings if required by your equipment. For removal, release the module latch and gently pull the transceiver straight out of the slot.

Recommendations

Use the module with OM1/OM2/OM3 multimode fiber according to your link distance requirements and check device compatibility lists when available. Avoid exposing the optical ports to dust; keep protective caps on when the module is not connected. Follow proper electrostatic discharge (ESD) precautions during handling and ensure firmware or hardware compatibility with your networking equipment.