Módulo transceptor SFP BlueOptics SFP-10G-BX-U-MT 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BX-U-MT is a fiber optic SFP transceiver module designed for 10 Gbit/s class connectivity. Built for SFP+ ports, this compact module supports a maximum data rate of 10000 Mbit/s and is intended for use in optical networking equipment where reliable high-speed links are required. Its form factor and electrical compatibility make it suitable for integration into switches, routers and media converters that accept SFP+ transceivers.

Advantages

This BlueOptics SFP+ transceiver delivers a standardized interface for high-speed optical links while maintaining a small, hot-pluggable form factor. It provides predictable performance for point-to-point fiber connections and simplifies upgrades from lower-speed modules by using the common SFP+ slot. The module emphasizes compatibility and ease of replacement without requiring changes to the host device's hardware.

Suitable for

• 10 Gbit/s fiber uplinks between switches and routers
• Data center server connections and aggregation links
• Metro and campus fiber networks requiring SFP+ ports
• Media converters and optical line cards that support SFP+ modules

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Physical form factor: SFP-sized hot-pluggable transceiver
• Optical medium: fiber optic (single-mode or multimode depends on system configuration)

How to use

Install the BlueOptics SFP-10G-BX-U-MT into a compatible SFP+ slot on your switch, router or media converter while the host device is powered according to the manufacturer's instructions. After seating the module, connect the appropriate fiber optic cable to the transceiver's optical port, ensuring correct connector type and polarity. Verify link status through the host device management interface and monitor the port to confirm successful negotiation at 10 Gbit/s.

Recommendations

Use factory-tested fiber patch cords and ensure the transceiver and corresponding remote module are matched for wavelength and fiber type. Keep optical connectors clean and capped when not in use to prevent signal loss. Follow the network equipment vendor's compatibility list for SFP+ modules and confirm supported modes (e.g., single-mode vs multimode) before deployment.