Módulo transceptor SFP BlueOptics SFP-10G-BXD1-40-BO 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BXD1-40-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s optical links. Housed in a metal casing with a silver finish and weighing approximately 20 g, this module provides a compact form factor for use in network switches, routers and other compatible hardware that accept SFP+ pluggable optics. The module is specified with an MTBF of 1,000,000 hours and supports single-mode fiber connections with an LC simplex-style interface as defined by SFP+ form-factor standards.

Advantages

The module supports a maximum data transfer rate of 10,000 Mbit/s and conforms to SFP+ electrical and mechanical specifications, enabling interoperability with MSA-compliant equipment. Its metal housing offers mechanical robustness and thermal conduction. With a low unit weight and standardized form factor, the transceiver is suitable for dense port deployments and replacement of compatible 10GBASE optics. The long MTBF rating indicates suitability for continuous operation in production environments.

Suitable for

• 10 Gbit/s single-mode fiber uplinks between switches and routers
• High-speed server-to-switch connections in data centers
• Optical links requiring LC simplex connectors and SFP+ form-factor modules

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Product colour: Silver (metal housing)
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Insert the SFP+ module into a compatible SFP+ slot on the host device until it clicks into place, ensuring the LC simplex optical connector and fiber patchcord are properly mated. Verify that the host hardware supports SFP+ optics and the required transmission protocol. After insertion, monitor link status via the device interface or management software and, if available, use any digital diagnostic functions provided by the host to confirm optical parameters and power levels.

Recommendations

Use single-mode fiber patchcords matched to the intended link distance and ensure LC simplex connectors are clean before mating. Confirm host compatibility with SFP+ modules and perform link tests after installation to validate signal levels and stability.