Módulo transceptor SFP BlueOptics SFP-10G-SR-PS 10000 Mbit/s SFP+ 850 nm

The BlueOptics SFP-10G-SR-PS is a fiber optic SFP+ transceiver module engineered for short-range 10 Gigabit Ethernet links. Operating at a nominal wavelength of 850 nm, the module supports a maximum data transfer rate of 10,000 Mbit/s and is compatible with SFP+ slots on switches, routers and network interface cards that accept small form-factor pluggable transceivers. The compact SFP form factor provides hot-pluggable convenience and is intended for use where high-bandwidth, low-latency fiber connections are required over multimode fiber.

Advantages

The module delivers 10 Gbps performance in an SFP+ footprint, enabling high-density deployment in data center and enterprise network environments without occupying larger transceiver bays. Its 850 nm wavelength is optimized for short-reach multimode fiber runs, providing predictable optical behaviour for typical campus and rack-to-rack connections. Compatibility with standard SFP+ interfaces ensures straightforward integration into existing network hardware that supports SFP+ transceivers.

Suitable for

• Short-range 10 Gigabit Ethernet links over multimode fiber
• Data center rack-to-rack connections and top-of-rack switching
• Enterprise campus backbone segments and server uplinks
• Network equipment with SFP+ ports requiring 850 nm SR transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Operating wavelength: 850 nm
• Form factor: SFP+ (hot-pluggable)
• Optimized for short-range multimode fiber links

How to use

Install the BlueOptics SFP-10G-SR-PS by inserting the module into a compatible SFP+ port until it locks into place. Attach LC-terminated multimode fiber cables to the module’s duplex connector, observing correct transmit/receive orientation. Ensure the connected network device is configured for 10 Gbps operation and verify link status through the device management interface. For safe removal, disable the port if required by the equipment, then press the module latch and pull the transceiver straight out.

Recommendations

Use OM3/OM4 multimode fiber for best performance at 10 Gbps over short distances and keep fiber connectors clean to maintain signal quality. Confirm that the host device supports SFP+ SR modules and the expected 850 nm optics before deployment. Follow standard electrostatic discharge (ESD) precautions when handling the transceiver and store unused modules in protective caps and anti-static packaging.