Módulo transceptor SFP BlueOptics SFP-10GLRLC-T-BO 10000 Mbit/s 1310 nm

The BlueOptics SFP-10GLRLC-T-BO is a compact SFP fiber-optic transceiver module designed for single-mode links with a maximum data transfer rate of 10000 Mbit/s. It operates at a wavelength of 1310 nm, has an SFP interface and a metal housing for mechanical durability. The module is powered by a 3.3 V input and weighs approximately 3 g, making it suitable for dense installations where size and weight are considerations.

Advantages

The module supports high-speed 10 Gbit/s optical transmission over single-mode fiber using an LC duplex connector and conforms to common SFP form-factor expectations. Its metal housing provides mechanical protection and thermal stability during operation. Small size and low weight enable flexible deployment in switches, routers, and other network equipment that accept SFP transceivers.

Suitable for

Key specifications

How to use

Before installation, verify that the target device supports SFP transceivers with the required data rate and wavelength. Power down or follow hot-swap guidelines for your equipment, insert the BlueOptics SFP-10GLRLC-T-BO into an appropriate SFP slot until it seats firmly, and connect LC duplex single-mode fiber patch cords with correct polarity. After insertion, check link status and configure interface settings on the switch or router as required by your network policies. Observe manufacturer guidance for supports such as Digital Diagnostics if available in the host device.

Recommendations

Use single-mode LC duplex patch cords that match the 1310 nm wavelength and observe correct transmit/receive polarity. Store and handle the transceiver using ESD precautions and replace protective dust caps on the connector when not in use to avoid contamination. Confirm that host equipment supports the SFP module and any digital diagnostic functions before deployment.