Módulo transceptor SFP BlueOptics SFP-553T-BO 25000 Mbit/s SFP28 1310 nm

The BlueOptics SFP-553T-BO is an SFP28 fiber optic transceiver module designed for 25 Gbit/s data transmission over single-mode fiber. Operating at a wavelength of 1310 nm with an LC duplex connector, this compact SFP28 module supports link distances up to 10,000 m and weighs approximately 20 g. The module follows MSA form-factor requirements and is intended for use in network equipment that accepts SFP28 transceivers.

Advantages

The module offers high data throughput at 25000 Mbit/s in an industry-standard SFP28 form factor, enabling dense and space-efficient installations. Its single-mode 1310 nm optics and LC duplex interface provide long-reach capability up to 10 km while maintaining immunity to electromagnetic interference typical of fiber links. The lightweight silver housing simplifies installation and handling in racks, switches, routers and other compatible devices.

Suitable for

Key specifications

How to use

Install the SFP-553T-BO into an SFP28-compliant port on your switch, router or network device while the device is powered down or following the manufacturer's hot-swap guidance. Connect an appropriate single-mode LC duplex patch cable between transceivers on each link end, ensure correct fiber polarity, and confirm link parameters in your device's interface status. Verify that the host hardware and firmware support 25G SFP28 modules and the 1310 nm LR optics before deployment.

Recommendations

Use single-mode fiber patch cords and maintain correct polarity (Tx/Rx) for optimal performance. Check that the network hardware supports SFP28 modules and, if required, enable or verify digital diagnostics monitoring (DDM/DOM) support to monitor supply voltage, optical power and temperature. For extended service life, avoid excessive bending of fiber cables and follow ESD precautions when handling the transceiver.