Módulo transceptor SFP BlueOptics SFP-BXD43-20KM-CP-BO 1250 Mbit/s

The BlueOptics SFP-BXD43-20KM-CP-BO is a compact SFP transceiver module designed for fiber optic network links. It supports a maximum data transfer rate of 1250 Mbit/s, comes in a metal housing and has a lightweight design of approximately 20 g. The module is intended for insertion into SFP ports on switches, routers and media converters to establish reliable point-to-point fiber connections over short to medium distances.

Advantages

This SFP transceiver provides a standardized SFP interface for easy hot-plug installation and compatibility with a wide range of network equipment. The metal housing offers mechanical protection and helps with heat dissipation while maintaining a small form factor. With a rated transfer rate of 1250 Mbit/s, the module supports common Ethernet and serial fiber applications that require stable data throughput. The lightweight construction reduces strain on connector assemblies and simplifies handling during installation.

Suitable for

Key specifications

How to use

Ensure the network device is powered according to the manufacturer's instructions. Insert the BlueOptics SFP transceiver into an empty SFP slot until it latches securely. Connect the appropriate fiber optic cable to the transceiver, observing correct connector type and polarity. After connection, verify link status and configuration on the network device and adjust speed or duplex settings if required by your equipment. For removal, power down or follow hot-swap procedures recommended by the host device, then disengage the latch and gently extract the module.

Recommendations

Use compatible single-mode or multimode fiber and matching connectors as specified by your network design. Keep dust caps on the transceiver when not in use, and handle the device by its housing to avoid contaminating optical interfaces. Verify compatibility with your switch or router vendor if the host enforces vendor checks.