Módulo transceptor SFP+ BlueOptics SFP+ER-BO 10000 Mbit/s 1550 nm

The BlueOptics SFP+ER-BO 10000 Mbit/s 1550 nm is an SFP+ fiber optic transceiver module designed for long-reach 10 Gbit/s links. Operating at a wavelength of 1550 nm and supporting data rates up to 10000 Mbit/s, this compact SFP+ form-factor module is intended for single-fiber duplex connections using LC Duplex connectors and provides transmission distances up to 40 km when used with suitable single-mode fiber. The module incorporates monitoring capabilities and is manufactured to meet common industry standards, with compliance to CE, FCC and RoHS and a mean time between failures (MTBF) rating of approximately 3,000,000 hours for reliable operation.

Advantages

The SFP+ER-BO combines a standardized SFP+ form factor with long-reach 1550 nm optics to deliver 10 Gbit/s links over extended distances while remaining compatible with typical enterprise and carrier-class hardware. Integrated digital diagnostics provide real-time information on supply voltage, laser current, optical transmit/receive power and temperature, supporting remote monitoring and troubleshooting. The module is produced using components that comply with MSA guidelines and industry quality standards, which contributes to consistent interoperability and an extended operational lifetime.

Suitable for

Key specifications

How to use

Install the SFP+ transceiver into an available SFP+ port of a compatible switch, router or other network device following the equipment vendor’s insertion and extraction procedures. Connect LC Duplex single-mode fiber patch cables to the transmit and receive ports, ensuring correct polarity. Verify link status and check the device management interface for DDM/DOM readings when supported by the host hardware. Ensure both ends of the optical link use matching wavelength and transceiver types for reliable operation.

Recommendations

Use this module with single-mode fiber and LC Duplex patch cables rated for long-reach 1550 nm transmission. Confirm host device compatibility with third-party SFP+ modules and enable DDM/DOM support on the host if diagnostics are required. Avoid bending or stressing fiber cables, and follow ESD precautions during handling. For critical or carrier environments, perform link validation and monitoring after installation to confirm optical power margins and operational stability.