Módulo transceptor SFP BlueOptics SFP-FC-S30-A-BO 155 Mbit/s 1310 nm

The BlueOptics SFP-FC-S30-A-BO is a single‑mode fiber optic SFP transceiver module designed for data transfer rates up to 155 Mbit/s. It operates at a wavelength of 1310 nm, uses an SFP form factor and an LC duplex-style optical interface. With a compact metal housing and a weight of approximately 0.02 kg, this transceiver is intended for integration into network equipment that accepts standard SFP modules and supports 100BASE‑LH/SDH/SONET or similar protocols at distances typical for 1310 nm single‑mode links.

Advantages

The module follows MSA SFP mechanical standards and is manufactured to be compatible with common network platforms that accept the referenced transceiver type. It provides single‑mode optical transmission with separate transmitter and receiver paths at 1310 nm, enabling bidirectional optical links over LC duplex cabling. The compact SFP form factor allows hot‑swapping and easy replacement in switches, routers, storage systems and other SFP‑capable hardware. The module is lightweight and finished in a silver housing.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP module into an empty SFP port on a compatible switch, router or storage device following the host device manufacturer’s instructions. Connect the LC duplex single‑mode fiber patch cable to the module’s connector, ensuring correct Tx/Rx orientation. Power on the host device and verify link status through the device management interface or LED indicators. If the host supports digital diagnostics monitoring (DDM/DOM), enable or read the diagnostic parameters according to the host documentation to monitor supply voltage, optical power and temperature if supported.

Recommendations

Use single‑mode LC duplex fiber patch cords of the appropriate quality and ensure correct Tx/Rx pairing. Confirm host compatibility with the transceiver type and enable DDM/DOM monitoring in the host when available to facilitate remote diagnostics and maintenance.