Módulo transceptor SFP BlueOptics SFP-P-1DH-BO 10000 Mbit/s 1310 nm

The BlueOptics SFP-P-1DH-BO is a fiber optic SFP+ transceiver module for high-speed network links. It supports a maximum data transfer rate of 10000 Mbit/s over single-mode fiber at a wavelength of 1310 nm. Housed in a metal casing and weighing approximately 3 g, the module operates at 3.3 V and provides an LC duplex interface for optical connection. The module follows MSA SFP+ form-factor conventions and is intended for use in network equipment that supports SFP+ 10GBASE-LR compatible transceivers.

Advantages

The transceiver offers 10 Gbit/s transmission capacity with 1310 nm optical operation and a compact metal housing for stable mechanical and thermal performance. Its SFP+ interface and LC duplex connector ensure wide interoperability with switches, routers and other networking hardware that accept MSA-compliant SFP+ modules. The module's low weight and standard 3.3 V supply make it suitable for a variety of installations where space and power considerations are relevant.

Suitable for

• 10G Ethernet links over single-mode fiber
• Long-reach optical connections in data centers and campus networks (up to typical 10 km class distances)
• Interconnection of switches, routers, storage systems and other SFP+-capable equipment

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm
• Connector: LC duplex
• Optical fiber type: Single-mode fiber
• Power supply: 3.3 V operating voltage
• Product colour: Silver (metal housing)
• Weight: approx. 0.003 kg

How to use

Install the BlueOptics SFP-P-1DH-BO by inserting the module into an SFP+ slot of compatible network equipment until it latches; connect an LC duplex single-mode patch cable between transceivers to establish an optical link. Ensure the host device supports SFP+ 10GBASE-LR modules and that the port is configured for the intended protocol (Ethernet, Fibre Channel over Ethernet, or other supported standards). Observe electrostatic discharge precautions when handling the transceiver and avoid touching the optical interfaces; keep the dust caps on until connection to prevent contamination.

Recommendations

For stable long-reach performance, use high-quality single-mode fiber and LC duplex patch cords, verify link parameters in the host device, and enable Digital Diagnostic Monitoring (DDM/DOM) in supported equipment to monitor supply voltage, laser bias current, optical transmit and receive power, and temperature.