Módulo transceptor SFP BlueOptics SFP-SWRG-LX-BO 1250 Mbit/s 1310 nm

The BlueOptics SFP-SWRG-LX-BO is a single-mode fiber SFP transceiver module designed for 1000BASE-LX applications. It supports a maximum data transfer rate of 1250 Mbit/s and operates at a wavelength of 1310 nm. The module follows MSA form-factor standards, uses an LC duplex connector for simultaneous transmit and receive over two fibers and is CE, FCC and RoHS compliant. The lightweight silver housing and compact SFP footprint make it suitable for integration into switches, routers and other networking equipment that accept standard SFP modules.

Advantages

The module provides Gigabit-capable optical transmission over single-mode fiber with a 1310 nm transmitter and receiver, enabling distances up to typical LX ranges when used with appropriate fiber and patching. Compatibility with MSA-compliant SFP ports ensures broad interoperability with major vendor hardware that supports 1000BASE-LX optics. Built-in design and component selection are intended to deliver stable optical performance and long operational lifetime with low power and small form factor.

Suitable for

• Gigabit Ethernet links between switches and routers over single-mode fiber
• Longer-reach connections within campus or metropolitan networks that require 1310 nm LX optics
• Interconnects in data centers and telecom rooms where SFP form factor is required
• Upgrading existing equipment to support fiber uplinks with LC duplex connections

Key specifications

• Interface type: SFP (MSA compliant)
• Data rate: up to 1250 Mbit/s (1.25 Gbit/s)
• Wavelength: 1310 nm (transmit and receive)
• Connector: LC duplex
• Fiber type: single-mode fiber
• Housing color: silver; weight approximately 20 g
• Standards compliance: CE, FCC, RoHS

How to use

Insert the BlueOptics SFP-SWRG-LX-BO into an empty SFP slot of compatible network equipment while the device is powered down or following the vendor’s hot-swap procedure. Connect an LC duplex single-mode patch cable ensuring correct TX/RX orientation between transceivers or to a patch panel. Verify link status and configure the port speed and protocol according to your switch or router documentation. If your hardware supports digital diagnostics (DDM/DOM), enable or query that function to monitor optical parameters such as received power and temperature.

Recommendations

For optimal range and signal quality, use single-mode fiber of appropriate grade and low-loss LC patch cords. Confirm vendor compatibility for 1000BASE-LX operation if the host device enforces OEM checks. Use DDM-compatible hosts when remote optical diagnostics are required, and follow static-handling precautions when installing or removing the module.