Módulo transceptor SFP BlueOptics SFP-XG-CPRI-LR-SM1310-BO 10000 Mbit/s

The BlueOptics SFP-XG-CPRI-LR-SM1310-BO is a silver SFP+ fiber optic transceiver module designed for 10 Gbit/s optical links over single-mode fiber. It uses an LC duplex connector and supports long-reach transmission up to 10,000 m at a wavelength of 1310 nm. The module follows MSA-compliant SFP+ form factor and is suitable for integration into compatible switches, routers and optical equipment that accept SFP+ 10GBASE-LR or CPRI interfaces. It weighs approximately 20 g and is intended for high-speed data communication and low-latency links in carrier, data center and campus networks.

Advantages

The transceiver provides a 10,000 Mbit/s maximum data transfer rate with single-mode fiber reach up to 10 km while using a compact SFP+ footprint and standard LC duplex connector. Compatibility with industry-standard SFP+ ports ensures broad interoperability with hardware that supports 10GBASE-LR or CPRI optics. Built to MSA specifications, the module supports optical transmit and receive functions at 1310 nm and is suitable for continuous operation in network environments.

Suitable for

Key specifications

How to use

Install the SFP-XG-CPRI-LR-SM1310-BO by inserting the module into a compatible SFP+ slot until it latches. Connect LC duplex single-mode patch cords to the TX and RX ports, ensuring correct polarity. Verify that the host device supports 10GBASE-LR or the intended CPRI profile and enable any required port settings in the switch or router management interface. For monitoring, enable Digital Diagnostics Monitoring (DDM/DOM) on supporting hardware to read real-time parameters such as optical power, temperature and supply voltage.

Recommendations

Use quality single-mode fiber and LC duplex connectors; maintain correct TX/RX polarity and follow electrostatic discharge (ESD) precautions when handling the module. Confirm hardware compatibility and, if available, enable DDM/DOM support on the host device for remote diagnostics. For best performance over long distances, use properly certified fiber patch cords and avoid tight bends or excessive stress on fiber runs.