Módulo transceptor SFP BlueOptics SFP10G-BX1330-40-BO 10000 Mbit/s SFP+

The BlueOptics SFP10G-BX1330-40-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s optical links. Housed in a metal casing and weighing approximately 2 g, the module operates at 3.3 V supply and provides a single LC simplex interface for single-mode fiber connections. It supports 10G transmission over long-reach links and is intended for integration into network equipment that accepts SFP+ modules.

Advantages

The module offers a compact metal form factor and SFP+ interface for compatibility with racks, switches and routers that accept SFP+ pluggable transceivers. With a 3.3 V operating voltage and a lightweight construction, it is suitable for dense installations where space and power considerations matter. The SFP10G-BX1330-40-BO supports high-speed 10 Gbit/s optical data transmission and is built to meet common industry mechanical and electrical conventions for SFP+ modules.

Suitable for

• 10 Gbit/s single-mode fiber uplinks between switches and routers
• High-speed links in data centers and server rooms
• Fiber connections between network appliances supporting SFP+ modules

Key specifications

• Interface type: SFP+
• Maximum data rate: 10000 Mbit/s (10 Gbit/s)
• Housing: metal
• Operating voltage: 3.3 V
• Weight: 0.002 kg
• Connector: LC simplex (single-fiber optical connection)
• Color: silver

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on network equipment while the device is powered down or following the manufacturer's hot-swap guidance. Connect an appropriate single-mode LC simplex fiber patch cable between this transceiver and the remote transceiver or patch panel. Ensure the host device firmware and hardware support SFP+ modules and any required digital diagnostic monitoring (DDM/DOM) features if remote monitoring is needed. After insertion and fiber connection, verify link status and negotiated speed in the host device management interface.

Recommendations

Use single-mode LC simplex patch cords and verify compatibility with the host device before installation. Keep transceiver dust plugs in place when not connected, avoid excessive bending of fiber cables, and follow ESD handling procedures during installation and removal.