Módulo transceptor SFP BlueOptics SFP25G-TR85-BO 25000 Mbit/s SFP28 850 nm

The BlueOptics SFP25G-TR85-BO is a 25G SFP28 fiber optic transceiver module designed for short-range multimode links. It supports a maximum data transfer rate of 25,000 Mbit/s over multimode fiber at an operating wavelength of 850 nm and uses an LC duplex connector. With a compact silver housing and a weight of approximately 20 g, this SFP28 module is intended for integration into switches, routers and other network hardware that accept SFP28 optics and require 25GBASE-SR connectivity over distances up to 100 meters.

Advantages

The module provides high-speed 25G connectivity in a small SFP28 form factor with standardized LC duplex interface and multimode operation at 850 nm. Its compact design and low weight make it simple to install and suitable for dense port environments. The transceiver is built to meet MSA-compliant mechanical and optical specifications and includes features aimed at reliable long-term operation, including a high MTBF value. The combination of standardized form factor, multimode compatibility and a 100 m reach supports flexible deployment in data center and enterprise cabling infrastructures.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP25G-TR85-BO into an SFP28-compatible port on network equipment while the device is powered down or following the equipment manufacturer's hot-plug instructions. Connect both ends of the link with appropriate multimode LC duplex fiber patch cords and ensure correct polarity. Configure the network interface as required by your switch or host operating system to enable 25G operation and verify link status in the device management interface. If Digital Diagnostics Monitoring (DDM/DOM) is available and supported by the host hardware, use the management interface to read optical and electrical parameters for ongoing monitoring.

Recommendations

Use high-quality multimode fiber (OM3/OM4 as appropriate) and matched LC duplex patch cords to achieve the specified 100 m reach. Verify hardware compatibility with the host device and check for DDM/DOM support if remote diagnostics are required. Follow ESD precautions during handling and avoid bending fiber beyond manufacturer-recommended radii to maintain optical performance.