Módulo transceptor SFP BlueOptics USFP-GB/SS13-4-BO 1250 Mbit/s 1310 nm

The BlueOptics USFP-GB/SS13-4-BO is an SFP fiber optic transceiver module designed for 1.25 Gigabit Ethernet links. It supports a maximum data transfer rate of 1250 Mbit/s and operates at a wavelength of 1310 nm over single-mode fiber. The module uses an LC connector in a compact silver housing and weighs approximately 20 g, offering a standardized MSA-compatible form factor for installation in switches, routers and media converters that accept SFP modules.

Advantages

This SFP transceiver provides reliable single-mode optical transmission up to 20,000 meters with a compact LC simplex interface. Built to industry MSA dimensions, it ensures physical compatibility with a wide range of network equipment. The module's 1310 nm wavelength and 1.25 Gbit/s rate are suitable for long-reach Ethernet and related high-speed applications, while the lightweight silver enclosure facilitates handling and installation.

Key specifications

How to use

Insert the BlueOptics SFP transceiver into an available SFP port of compatible network equipment until it clicks into place, following the equipment manufacturer's hot-swap or power-down recommendations. Connect an LC single-mode patch cable to the transceiver's LC connector and route the fiber to the corresponding endpoint or patch panel. Configure the device's interface settings according to your network requirements, ensuring the equipment recognizes the SFP module and the link parameters (speed, duplex and any optical diagnostics) are set as needed.

Recommendations

Use single-mode LC patch cables rated for the intended distance and avoid bending the fiber beyond its minimum bend radius. Verify compatibility with the host device and enable any digital diagnostic monitoring (DDM/DOM) features supported by your equipment to monitor optical parameters and simplify maintenance.