Módulo transceptor SFP28 BlueOptics 407-BBZS-BO cobre 25000 Mbit/s

The BlueOptics 407-BBZS-BO is an SFP28 copper transceiver module designed for high-speed networking with a maximum data transfer rate of 25000 Mbit/s. The module uses an SFP28 interface, has a compact form factor and a grey housing with a weight of approximately 40 g, making it suitable for installation in compatible network ports that accept SFP28 modules. It supports short-reach connections and is intended for applications that require reliable 25G connectivity.

Advantages

The module provides 25G data transmission over a standardized SFP28 interface enabling compatibility with hardware that supports SFP28 pluggables. Its lightweight metal/plastic housing simplifies handling and installation. The transceiver is built to industry mechanical standards and focuses on providing stable 25G throughput for high-bandwidth links while keeping a small footprint and low weight for dense deployment scenarios.

Suitable for

• 25G Ethernet uplinks and switch interconnects
• High-bandwidth server connections and storage networking
• Data center short-reach fiber links where SFP28 modules are supported

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s
• Operating wavelength: 850 nm
• Module colour: Grey
• Weight: 0.04 kg

How to use

Insert the SFP28 transceiver into a compatible SFP28 port until it clicks into place and secure any retaining latch according to the host device instructions. Connect appropriate duplex multimode fiber or copper patching as required by the link type and ensure both ends use matched transceiver types and link parameters. Verify link status in the host device management interface and confirm that the negotiated speed and diagnostics are as expected before placing the link into production.

Recommendations

Ensure the host hardware officially supports SFP28 modules and, if applicable, the specific 25G transceiver type. Use suitable multimode fiber patch cords and maintain clean connector endfaces. Monitor link health via the host diagnostics and follow manufacturer guidance for insertion/removal to avoid connector damage.