Módulo transceptor SFP28 BlueOptics E25GSFP28LRX 25000 Mbit/s 1310 nm

The BlueOptics E25GSFP28LRX is an SFP28 fiber optic transceiver module engineered for 25 Gbit/s class links. It supports a maximum data transfer rate of 25000 Mbit/s and transmits on a 1310 nm wavelength, providing a balance between reach and compatibility for fiber-based network infrastructures. The module is compact and lightweight (approximately 20 g) and has a silver housing suitable for standard SFP28 ports in switches, routers and optical transceivers shelves.

Advantages

The module offers a standardized SFP28 interface for straightforward hot-pluggable installation and interoperability with equipment that accepts SFP28 optics. Its 1310 nm wavelength supports single-mode fiber transmission for medium to long reach links depending on system margin, while the 25 Gbit/s capability fits high-performance server-to-switch, switch-to-switch and aggregation connections. The small form factor and low weight simplify inventory and installation in dense network environments.

Suitable for

• 25 Gbit/s server-to-switch connections
• Switch-to-switch uplinks and aggregation
• Data center and campus fiber links using single-mode fiber
• Optical interface upgrades where SFP28 ports are available

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s
• Operating wavelength: 1310 nm
• Form factor: SFP28 hot-pluggable transceiver
• Typical application: single-mode fiber optical links
• Weight: 0.02 kg
• Housing colour: silver

How to use

Insert the BlueOptics E25GSFP28LRX into an empty SFP28 port on compatible network equipment while the host device is powered on or off according to the equipment manual; the module is hot-pluggable. Connect the single-mode fiber cable using the appropriate connector type for your network (ensure correct polarity). Verify link status and speed on the host device and configure interface parameters if required by your switch or router firmware. Follow the equipment manufacturer’s instructions for firmware compatibility and optical power budgeting.

Recommendations

Use the transceiver with single-mode fiber and the correct connector type for 1310 nm transmission, check compatibility lists for confirmed interoperability with your network gear, and observe optical power and distance specifications in system design to ensure reliable 25 Gbit/s links.