Módulo transceptor SFP28 BlueOptics S26361-F4055-E701-BO 25000 Mbit/s

The BlueOptics S26361-F4055-E701-BO is an SFP28 multimode fiber optic transceiver module supporting a maximum data transfer rate of 25,000 Mbit/s. It operates at an 850 nm wavelength and uses an LC duplex connector following MSA standards, providing simultaneous transmit and receive channels for short-range optical links. The module is designed for use in common networking hardware platforms that accept 25GBASE-SR SFP28 transceivers and is certified to CE, FCC and RoHS requirements. With a manufacturer-stated MTBF of 3,000,000 hours and a compact silver housing, this SFP28 module targets reliable high-speed optical interconnects in data center and enterprise environments.

Advantages

The transceiver offers 25 Gbit/s nominal bandwidth over multimode fiber with standardized LC duplex connectivity and full MSA compatibility, enabling straightforward replacement or upgrade of compatible 25GBASE-SR ports. Built-in digital diagnostics (DDM/DOM) provides real-time monitoring of operating parameters such as supply voltage, laser current, optical transmit and receive power, and temperature, simplifying troubleshooting and remote maintenance. Components and design choices prioritize interoperability and extended service life, contributing to long-term availability and predictable performance in high-density networking installations.

Suitable for

Key specifications

How to use

Install the transceiver into an empty SFP28 port on a compatible switch, router or storage device until it clicks into place, then connect LC duplex multimode fiber patch cables to the transmit and receive ports. Ensure the host hardware supports 25GBASE-SR SFP28 modules and, if required, enable or verify DDM/DOM support in the device management interface to access diagnostic information. Observe standard ESD handling procedures during installation and verify link status using the host device indicators or management software.

Recommendations

To maximize reliability, match the multimode fiber type and patch cable specifications to short-range 25G applications (e.g., OM3/OM4 where appropriate), maintain clean LC connectors when making connections, and confirm that the host platform explicitly supports SFP28 transceivers of this type. Use DDM/DOM output for preventive monitoring and perform periodic inspections of optical connectors and cable routing to reduce signal loss and maintain link availability.